goglroof.blogg.se - Pfsense ntopng disk space

#Pfsense ntopng disk space install#
#Pfsense ntopng disk space drivers#

Cryptographic Hardware: AES-NI CPU-based Acceleration.

System -> Advanced -> Miscellaneous -> Cryptographic & Thermal Hardware:.

System -> Advanced -> Miscellaneous -> RAM Disk Settings:Įnable capabilities of the CPU (Intel Celeron N3450).

If you are planning on using pfSense as a basic firewall/router you should consider minimising the writes to the eMMC storage, though if you are planning on using additional packages like ntopng it will need more space than can be provided by a RAM Disk

After booting back up the additional NIC is detected, but re0 was the 2.5GbE NIC, re1 the left hand onboard NIC and re2 the rightmost NIC.

If not present add the following configuration items to /boot/nf.

#Pfsense ntopng disk space install#

pkg install -f -y realtek-re-kmod-196.04.txz.

#Pfsense ntopng disk space drivers#

The 2.5GbE network card (Realtek RTL8125B) wasn’t detected after installation and required updated Realtek drivers to be installed. The left hand NIC was re0 and the other re1 The two onboard NICs are identified as Realtek PCIe GbE Family Controller and worked out of the box, though FreeBSD 12 which pfSense 2.6 is built on doesn’t include the latest drivers. After installation completes I had to enter the BIOS and change the Boot option to MMC.The ZimaBoard supports up to 2 x SATA drives, depending on the features planned to be used on pfSense, consideration should be given to using a SATA SSD or HDD.Boot the ZimaBoard and follow the wizard to install pfSense, selecting the eMMC storage#.Insert USB Flash drive now containing pfSense installing image.Attach a display and keyboard to the ZimaBoard.Write the USB Image to a USB Flash drive using Balena Etcher (or similar).Download the latest pfSense USB Image from:.Here are the steps I followed to get pfSense 2.6.0 up and running on the ZimaBoard: Note: This isn’t the setup I finally ended up running, but this is the journey I went on. The usual riser bracket also has to be removed as it would otherwise foul the case. When I backed the project, I also bought an extra NIC as I needed 3 connections if I was going to have a backup WAN link, however, there isn’t a way to mount the PCIe Network Card into the ZimaBoard and keep it secured. ZimaBoard 432 with an additional 2.5Gbps NIC installed